Hedgehog Central banner

1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Ok, paranoid hedgie owner. I just got my CHE set up done last night, and while I was awake everything seemed fine. Heat was at the temp I wanted and all, but this morning the temp had dropped. There are two lights on my Zilla Temp Controlled, one for power one for heat source. The power one is green and the heat source is red. Should they both be green? Help I’m new to this.
 

·
Registered
Joined
·
902 Posts
"Temperature Controller with electronic technology and LED heating indicator. Two LED indicators, green for "Power" and red for "Heating.""

I would check your manual.
 

·
Registered
Joined
·
2,716 Posts
You'll have to check with your manual but it seems as if it should be green. Over the years it seems most things like that will be red until they reach the right temperature but I don't have that product so you'll want to read up on it to make sure its operating right :)
 

·
Registered
Joined
·
5,136 Posts
The green one will be on as long as the thermostat is plugged in. The red light for heating is just letting you know that it is heating (under the designated temp) or if it is off (at or above the designated temp). The heating one will always be red, or off. :)
 
1 - 5 of 5 Posts
Top