Hedgehog Central banner
1 - 2 of 2 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
does it matter what type of bin to choose from when it comes to wanting to connect the two.

i brought a 95qt and a 60gt bin. one from office depot and the other from joann fabric. they both are the same brand of bin. but i was thinking of how it would work, i also brought the ferret bubble tube. i know once the holes are there i put the tube through and put the connector inside the bin and it will help hold it in place but the bins sides are in an angle, so how would it work, or is there a bin that the sides are straight?????
 

·
Registered
Joined
·
60 Posts
Hope this picture helps answer your question, just make sure the section of tube you use is long enough to bridge the gap that is left by the slanted sides
I imagine with a ferret tube it will sag a little, but that should not be a problem :)

 
1 - 2 of 2 Posts
Top